Bluto: Difference between revisions
No edit summary |
|||
| Line 2: | Line 2: | ||
* motherboard: [https://www.asus.com/us/motherboards-components/motherboards/tuf-gaming/tuf-gaming-z790-plus-wifi/ ASUS Z790-PLUS WIFI] ([https://www.amazon.com/dp/B0BQD58D96 amazon]) | * motherboard: [https://www.asus.com/us/motherboards-components/motherboards/tuf-gaming/tuf-gaming-z790-plus-wifi/ ASUS Z790-PLUS WIFI] ([https://www.amazon.com/dp/B0BQD58D96 amazon]) | ||
Is one 8-pin PSU connector enough? There are 12 pins. [https://www.reddit.com/r/buildapc/comments/14tfyg2/two_8pin_connectors_on_a_z790_motherboard/ According to this], I might as well fill all 12. | |||
* memory: G.Skill Trident Z 5 RGB (DDR5) | * memory: G.Skill Trident Z 5 RGB (DDR5) | ||
* GPU: [https://www.zotac.com/us/product/graphics_card/zotac-gaming-geforce-rtx-4090-trinity-oc-white-edition ZOTAC RTX 4090] ([https://www.amazon.com/dp/B0BGJRHX1X amazon]) | * GPU: [https://www.zotac.com/us/product/graphics_card/zotac-gaming-geforce-rtx-4090-trinity-oc-white-edition ZOTAC RTX 4090] ([https://www.amazon.com/dp/B0BGJRHX1X amazon]) | ||
Revision as of 17:42, 24 September 2023
2023/09/22 The beast has landed.
- motherboard: ASUS Z790-PLUS WIFI (amazon)
Is one 8-pin PSU connector enough? There are 12 pins. According to this, I might as well fill all 12.
- memory: G.Skill Trident Z 5 RGB (DDR5)
- GPU: ZOTAC RTX 4090 (amazon)
- CPU: Intel Core i9-13900K (amazon)
- CPU cooler: (amazon)
- PSU: 1000W (ouch) (amazon)
- Drives: WD M.2 4TB (amazon), 1TB (amazon)
History
- shit motherboard I had to send back: Gigabyte Z690 Aero D (amazon)
AFTER A DAY OF WORK I STILL FAILED with my Gigabyte Z690. My tricks:
- I used an old USB 2.0 stick that "flashes" on write (remember those?) so i could tell it was reading from the stick. Without being able to tell I was just shooting in the dark.
- I grabbed an older firmware F21 instead of F26 (which would not work), based on some far flung internet comment in some lost forum.
- I renamed the BIOS firmware to "gigabit.bin". That was weird but I think required.
- I stripped everything out but the CPU and motherboard/CPU power connectors.
- I flipped on the power switch, pressed the case power button to start it up, held the power button to power it down into "standby".
- I pressed the Q-Flash button on the mobo, saw the thumb flash, then saw the Q-Flash led on the mobo start to flash too, indicating it actually liked the BIOS and would consume it.
- I redid everything again to go from F21 to F26.
- After finally getting it to start POST, it stuck on codes listed as "internal use" HOW DOES THAT HELP ME? The memory light was lit. I was done and sent it back for an ASUS board.