Hive

TODO

move mack data to safe, remove torrent symlinks, update windoze mapped drive and kodi
stop rtorrent, move sassy to safe, update edit_torrent_shows links, update torrent symlinks, update all SharedDownload folders (via mh-setup-samba!)
move splat data to safe, update edit_torrent_shows links, update torrent symlinks
remove mack, sassy, splat; safe should now have 478 + 200 + 3100 = 3.8 TB used (ouch)
DEEP PURGE; we will need to move softraid, reservoir, tv-mind, film to safe and grim; this will require deep purges of all shit; check that there are no symlinks
continue migration until we have 7 slots free (16 - 7 safe - 2 grim)
add 7 new BIG ssds in new raidz array
rinse and repeat

FreeNAS provides storage via Pools. A pool is a bunch of raw drives gathered and managed as a set. My pools are one of these:

single drive: no FreeNAS advantage other than health checks
raid1 pair: mirrored drives give normal write speeds, fast reads, single-fail redundancy, costs half of storage potential
raid0 pair: striped drives gives fast writes, normal reads, no redundancy, no storage cost
raid of multiple drives: FreeNAS optimization of read/write speed, redundancy, storage potential

The three levels of raid are:

raidz: one drive is consumed just for parity (no data storage, ie you only get (n-1) storage total), and one drive can be lost without losing any data; fastest
raidz2: two drives for parity, two can be lost
raidz3: three drives for parity, three can be lost; slowest

Pool	Capacity	Type	Drives
sassy	0.2 TB	single	250GB ssd
splat	3.6 TB	raid0	1.82 TB hdd x2
mack	0.9 TB	single	1 TB ssd
reservoir	2.7 TB	single	2.73 TB hdd
grim	7.2 TB	raid0	3.64 TB ssd x2
safe	6 TB	raidz	1 TB ssd x7

Every pool should have one dataset. This is where we set the permissions, important for SAMBA access.

Dataset settings:

name #pool#-ds
share type SMB
user m
group m
ACL
 who everyone@
 type Allow
 Perm type Basic
 Perm Full control
 Flags type Basic
 Flags Inherit

Share each dataset as a Samba share under:

Sharing > Windows Shares (SMB)

Use the pool name for the share name.

Use the same ACL as for the dataset.

Plugged in to SATA 1, 2, 3 and U.2 1, 2, 3, 4. NOTE: to get U.2 drives to be recognized by Melange ASUS mobo required a BIOS change:

Bios > advanced > onboard devices config > U.2 mode (bottom) > SATA (NOT PCI-E)